I had a
problem with my new Elecraft K-Pod. Because, after about one hour, I
had forgotten, which function was programmed of which buttom. So I
decided to construct Label-Wings for my K-Pod. I printed this with a 3d
printer. This Wings, I could labels with my brother p-touch. Also, my
K-Pod, with it's wings, take not much place in my Shack-Table. The wings
could be installed with the original screws from the K-Pod. I have
printed this with ABS filament.
Here ist the file for the Label-Wings: k-pod.obj
If you rebuild this Label-Wings, only at your own risk.